DIY Aloe Vera Leave-In Hair Moisturizer

Step 1

Prepare a double-boiler system by adding about 1 inch of water in a wide, flat-bottomed sauté pan. Put the pan on the stove and set the stove on low heat.

Step 2

Weigh the water phase ingredients into a heat-resistant glass measuring cup. Cover the container with aluminum foil to avoid evaporation of water content.

Step 3

Weigh the oil phase ingredients into a second heat-resistant glass measuring cup.

Step 4

Place both measuring cups in your prepared double boiler system to melt everything through.

Step 5

After about 20–30 minutes the oil part should be completely melted and the water part should be warmed.

Step 6

Remove the double boiler pan from the heat, remove the foil and pour the oil part into the water part.

Step 7

Mix the water and oil mixture with a spoon to combine them. Stir the spoon for 10-15 seconds.

Step 8

Now, immediately grab your immersion blender and begin blending the lotion.

Step 9

Blend for about a minute, leave to cool for ten minutes.

Step 10

After 10 minutes, blend for another minute or two, and repeat this blend-cool-blend cycle until the glass measuring cup is barely warm to the touch and the lotion is thick and creamy.

Step 11

When the lotion is cool it’s time to incorporate cool-down phase ingredients.

Step 12

Weigh down the liquid germall plus preservative and vitamin e oil and add them into the cream. Then, add essential oil to the cream.

Step 13

Mix everything well and store it in an airtight jar.

Step 14

Just scoop a little leave-in hair conditioner or cream with your cleaned fingers and apply to your hair. You can leave it overnight and wash the hair with shampoo or simply use it as a leave-in conditioner to control frizzy and dry hair.

Step 15

Prepare a double-boiler system by adding about 1 inch of water in a wide, flat-bottomed sauté pan. Put the pan on the stove and set the stove on low heat.

Step 16

Weigh the water phase ingredients into a heat-resistant glass measuring cup. Cover the container with aluminum foil to avoid evaporation of water content.

Step 17

Weigh the oil phase ingredients into a second heat-resistant glass measuring cup.

Step 18

Place both measuring cups in your prepared double boiler system to melt everything through.

Step 19

After about 20–30 minutes the oil part should be completely melted and the water part should be warmed.

Step 20

Remove the double boiler pan from the heat, remove the foil and pour the oil part into the water part.

Step 21

Mix the water and oil mixture with a spoon to combine them. Stir the spoon for 10-15 seconds.

Step 22

Now, immediately grab your immersion blender and begin blending the lotion.

Step 23

Blend for about a minute, leave to cool for ten minutes.

Step 24

After 10 minutes, blend for another minute or two, and repeat this blend-cool-blend cycle until the glass measuring cup is barely warm to the touch and the lotion is thick and creamy.

Step 25

When the lotion is cool it’s time to incorporate cool-down phase ingredients.

Step 26

Weigh down the liquid germall plus preservative and vitamin e oil and add them into the cream. Then, add essential oil to the cream.

Step 27

Mix everything well and store it in an airtight jar.

Step 28

Just scoop a little leave-in hair conditioner or cream with your cleaned fingers and apply to your hair. You can leave it overnight and wash the hair with shampoo or simply use it as a leave-in conditioner to control frizzy and dry hair.